Removing base unit cover
REMOVING BASE UNIT COVER:
1) Turn the power off on computer and all peripherals.
2) Switch the surge protector off and unplug the power cable from the wall socket.
WARNING: Ensure all components are turned off and power cable is disconnected.
3) Pull the base unit out slightly so that the rear panel is accessible.
4) Carefully remove all cables from back of base unit.
a) Check each cable for screw or finger-screw connections. Unscrew connectors.
b) Note the location and orientation of each connector during removal. (If necessary, draw a wiring diagram or tag the end of each cable noting its destination.
c) Gently remove each cable. Do not force or bend connectors to avoid costly damage to the connector or pins.
5) Remove screws from the top and sides of the back edge of the base unit. Store them together in a safe location.
6) Grasp the cover along the sides with two hands. SLOWLY and GENTLY slide the cover forward and off. Set it aside.
CAUTION: Watch carefully to ensure parts of cover DO NOT catch on power or ribbon cables inside the base unit.
7) Ground yourself by touching the metal chassis with a finger.